Husqvarna DM650, Operator'S Manual

Page: 6 / 68

ASSEMBLING AND ADJUSTMENTS
6 – English
Assemb ly
Assemb ling on stand
• See instructions in the operator' s manual for the
stand in question.
Fitting the drill bit
• Fit the supplied friction ring on the spindle shaft.
• Assemble the drill and make sure it is fastened
properly.
Dismantling/c hanging the drill bit
• Use the accompanying 32 mm wrench to lock the
spindle axle.
• Undo the drill by turning it clockwise.
Connect the cooling water
• Connect the water hose to the water supply.
Connect a po wer cable
• Connect the machine to the power unit.
• Connect the power unit to a grounded outlet
• Turn on the power unit switch.
!
W ARNING! The machine should be
switched off with the power cable
disconnected from the outlet.
!
CA UTION! The drill bit and the
surrounding area is very hot after use.
Leave machine to cool off before
removing the drill bit. Use protective
gloves.
NO TICE! The friction ring is used to prevent damage on
the shaft and the gear box during the dismantiling of the
drill bit.
NO TICE! Fierce knocks can damage gearbox and drill
stand.