Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Speak to a Husqvarna service agent.
Maintenance
Before
each use
After
each use
Daily
After the
first 100 h
After
each 300
h
Make sure that movable parts function correctly and
move freely.
*
Make sure the cutting tool is sharp and clean.
*
Make sure the PRCD functions correctly.
WARNING: Not applicable for 110V type
sold in United Kingdom and Ireland. Refer
to
PRCD on page 10
.
X
Examine the power cord, other cables, and the power
plug for damage.
*
*
Make sure the handles and holding surfaces are dry,
clean and free of oil and grease.
*
*
Make sure the product is clean.
X
X
Examine the shaft seals for damage/water leakage.
X
Make sure that the nuts and screws are tight.
*
Make sure that the ON/OFF switch operates correctly.
X
Replace the gear oil.
O
Examine the carbon brushes for damage.
X
To clean the product
CAUTION: Make sure that no water goes
into the motor or the gearbox.
CAUTION: Do not use running water to
clean the product.
• Use a dry or moist cloth to clean the product.
• Remove blockage from all air openings. A blocked
air intake decreases the performance of the product
and can cause the motor to become too hot.
• Clean and lubricate the spindle shaft thread.
To do maintenance of the diamond drill
bit
• Make sure that the diamond tools segments are
sharp. Sharpen blunt diamond segments with a SiC
grind stone.
• Make sure that there is no vibration in the drill bit. If
there is vibration in the drill bit, the diamond
segments can come loose.
• Make sure that the diamond segments are
sufficiently larger than the inner and outer diameter
of the drill bit tube.
• Lubricate the drill bit thread with water resistant
grease. This makes it easy to loosen the tool.
• Make sure that the radial run out at the diamond
segments of the drill bit is not more than 1 mm.
To replace the gear oil
CAUTION: If there is gear oil leakage, stop
the product and speak to an approved
service center. The gear becomes damaged
if the gear oil level is not sufficient.
• Let an approved Husqvarna service center replace
the gear oil.
14
1188 - 009 - 12.10.2020
