• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the motor manual that is supplied by the motor
manufacturer.
• Connect the product to a grounded mains outlet.
• Make sure that the mains voltage agrees with the
rating plate on the product.
• Do the daily maintenance. Refer to
.
To install the floating disc
1. Put the floating disc on a hard flat surface.
2. Put the product on top of the floating disc.
3. Align the center of the blade assembly with the
center of the floating disc.
4. Turn the floating disc until the blades engage in the
brackets on the floating disc.
CAUTION: Make sure that the floating
disc is correctly installed before you
operate the product. An incorrectly
installed floating disc does not give a
smooth result.
To start the product
1. Connect the power plug (A) to an extension cable.
B
C
A
2. Connect the extension cable to a power outlet, 230
V, 10 A fuse.
WARNING: Make sure that the power
outlet has RCD protection.
3. Pull the quick stop handle (B) until it is against the
handlebar. Keep the quick stop handle in this
position during operation.
4. Push the start button (C).
5. During operation, hold the handlebar and the quick
stop handle with two hands.
Working techniques
The floating operation removes dents on the concrete
surface. The concrete surface must be sufficiently hard
before the floating operation. The concrete surface is
sufficiently hard when a shoe gives only a small recess
on the concrete surface.
When the floating operation is completed, the concrete
surface is prepared for the troweling operation. The
troweling operation increases the density of the concrete
surface and makes it smooth and hard.
CAUTION: Look for loose stones on the
concrete surface during operation. Loose
stones can make marks that are not easy to
remove from the concrete surface.
To do the floating operation
page 7
.
2. Turn the blade adjustment knob until there is tension
in the cable.
3. Move the product across the concrete surface.
4. Stop the product and remove it from the concrete
surface.
CAUTION: Do not let the product stay
stationary on the concrete surface. This
can cause marks and damages to the
concrete surface. When the product
stops, immediately lift the product from
the concrete surface.
1132 - 001 - 06.04.2020
7
