Husqvarna 966503401, Operator'S Manual

Page: 33 / 60

33
oPERATIoN
Manual Transport
When pushing or pulling the mower, engage the EZT
(Integrated Zeroturn Transaxle) bypass linkages. The
EZT bypass linkages are located on the rear of the
frame, below the rear engine guard.
Raise the deck into the highest cutting 1.
position.
Pull the EZT bypass linkages up and out of
2.
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
To reengage the EZT’s to drive, reverse the
3.
above procedure.
load the machine into truck or trailer by driving up
ramps in low gear. Do NoT lIfT! The machine is not
intended to be lifted by hand.
8058-032
Bypass linkage, EZT engaged
8058-033
Bypass linkage, EZT locked in the bypass position
WARNING!
Make no adjustments without:
the engine stopped, •
the ignition key removed, •
the parking brake activated •