Note:
Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
• Always use a fuel container with an antispill valve.
• If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
• Make sure that the area near the fuel tank cap is
clean.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To add fuel to the fuel tank
1. Stop the product.
2. Put the product on a flat surface.
3. Loosen the fuel tank cap to release the pressure in
the fuel tank.
4. Remove the fuel tank cap.
5. Fill the fuel tank to 80%.
6. Tighten the fuel tank cap fully.
7. Make sure that there is no leak in the fuel tank.
Before you operate the product
WARNING:
Read the safety
instructions before you operate the product.
• Use the blower with the lowest possible throttle. A
lower throttle means less noise and less dust, and it
is also easier to keep control over the rubbish
collected together/moved. Use a rake or a brush to
release rubbish stuck to the ground.
• Hold the opening of the blower as close to the
ground as possible. Utilize the entire length of the
blow pipe to keep the air current close to the ground.
Clean up afterwards. Make sure that you have not
blown rubbish into someone’s garden. Operate
power equipment only at reasonable hours, not early
in the morning or late at night when people might be
disturbed. Comply with times listed in local
ordinances.
• This blower is a backpack type, and is carried using
a shoulder harness while operating. It is operated
and controlled with the handle on the tube using the
right hand.
• The speed of the air jet is regulated by means of the
throttle. Select the speed best suited for respective
tasks.
• Check that the air intake is not blocked, for example,
by leaves or rubbish. A clogged air intake reduces
the machine’s blowing capacity and increases the
engine’s working temperature, which can result in
engine failure. Stop the engine and remove the
object.
• Be aware of the wind direction. Work with the wind to
make your work easier.
• Using the blower to move large piles is time
consuming and creates unnecessary noise.
• Keep a good balance and a firm foothold.
• When work is finished the machine should be stored
vertically.
To operate the throttle switch :580BTS
Mark III
• Apply full throttle (A).
• Apply 1/3 speed (B).
• Apply idle speed (C).
• Stop the product with the stop switch (D).
A
B
C
D
To operate the throttle switch :580BFS
Mark III
• Apply full throttle (1).
• Apply 1/3 speed (2).
• Apply Idle speed (3).
• Stop the product with the stop switch (4).
1
2
3
4
1667 - 002 - 19.04.2021
13
Summary of Contents for 580BFS Mark III
Page 63: ...1667 002 19 04 2021 63 ...
