Husqvarna 580BFS Mark II, Operator'S Manual

Page: 16 / 60

2. Remove the air filter cover (A).
A
B
C
3. Remove the foam filter (B) and the paper filter (C)
from the filter frame.
4. Replace the paper filter (C).
5. Clean the foam filter (B) with warm soap water.
Note: An air filter that is used for a long time can not
be fully cleaned. Replace the air filter regularly and
always replace a defective air filter.
6. Make sure that the foam filter (B) is dry.
7. Clean the inner surface of the air filter cover with a
brush (A).
To replace the harness
WARNING: A damaged harness can make
the product fall and cause injuries.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the hanger.
4. Pull the new strap through the hanger.
5. Attach the clamp to the new strap.
Transportation and storage
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before transportation or before
long-term storage. Push the air purge bulb to make
sure that all fuel is removed. Discard the fuel at an
applicable disposal location.
• Make sure that the product is clean and that a
complete service is done before long time storage.
• Remove the spark plug and put approximately 15 ml
of two-stroke oil into the cylinder. Turn the product 3
times and attach the spark plug again.
• Attach the product safely during transportation.
16 936 - 004 -