point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.
To prepare the product for start
1. Press the air purge again and again until the fuel
starts to fill the bulb.
Note:
It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
WARNING:
The cutting attachment
will start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING:
Read the warning
instructions in the safety chapter before you
).
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION:
Do not use your feet!
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING:
Do not twist the starter
rope around your hand.
5. Pull the cord quickly and with power.
CAUTION:
Do not pull the starter
rope all the way out and do not let go off
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
6. Pull the starter rope until the engine starts or for a
maximum of 5 times.
7. Reset the choke when the engine starts or after you
pull the starter rope 5 times.
8. If it is necessary, pull the starter rope again and
again until the engine starts.
9. Let the engine run for 10 seconds.
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
1069 - 008 - 31.10.2022
17
Summary of Contents for 535RX
Page 98: ...98 1069 008 31 10 2022 ...
Page 99: ...1069 008 31 10 2022 99 ...
