Husqvarna 535LST, Operator'S Manual

Page: 14 / 72

To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer cord can be used
to remove cut grass from an area.
1. Hold the trimmer head and its cord parallel to the
ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer cord
to prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
Maintenance
To adjust the idle speed
Your Husqvarna product is designed and made to
specifications that decrease harmful emissions.
• Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
• Adjust the idle speed with the idle adjustment screw
T which is identified with "T" mark.
WARNING: If the cutting attachment
does not stop when you adjust the idle
speed, turn to your nearest servicing
dealer. Do not use the product until it is
correctly adjusted or repaired.
• The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be
below the speed when the cutting attachment starts
to turn.
1. Turn the idle adjustment screw clockwise until the
cutting attachment starts to turn.
2. Turn the idle adjustment screw counterclockwise
until the cutting attachment stops.
Note: See Technical data on page 19 for the
recommended idle speed.
14 1011 - 002 - 01.02.2019