ASSEMBLY
12 – English
1154807-49 rev.no 1 2015-06-15
Fitting the handlebar
•
Remove the screw at the rear of the throttle handle.
•
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
•
Align the screw hole in the throttle handle with the hole
in the handlebar.
•
Refit the screw in the hole in the rear of the throttle
handle.
•
Screw the screw through the handle and handlebar.
Tighten it.
•
Loosen the screws on the handle bar bracket.
•
Position the handle bar bracket as shown.
•
Tighten the screws.
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness. Tighten the knob.
Assembling and dismantling the
two-piece shaft (525RK)
Assembly
•
Loosen the coupling by turning the knob counter-
clockwise.
•
Align the tab of the attachment (A) with the arrow on
the coupling (B).
•
Push the attachment into the coupling until the
attachment snaps into place.
•
Before using the unit, tighten the knob securely.
A
B
Summary of Contents for 525RK
