Husqvarna 525 LST, Operator'S Manual

Page: 11 / 36

To install the suspension ring (525LST,
525RJD)
1. Install the suspension ring to the shaft between the
rear handle and the loop handle.
2. Adjust the ring to make the product balanced and
easy to use.
3. Attach the harness to the suspension ring. Use the
harness when you operate the product.
To assemble the two-piece shaft
(525RJD)
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
A
B
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
To disassemble the two-piece shaft
(525RJD)
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
attached to.
4. Pull the attachment straight out of the coupling.
C
To assemble the cutting attachment
guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to Accessories on page 26 .
2. Put the cutting attachment guard onto the fitting on
the shaft.
1363 - 001 - 25.10.2019 11