8
STEP 4: (SEE FIGURE 4)
• Install 1/2" x 1-1/2" washers onto the two rear bolts
in the right side of the tractor frame, unless there
is an engine mounting plate present (depicted with
dotted lines). If there is a plate present, do not install a
washer on the 3/8" bolt inserted through the plate.
•
Place the R.H. Side Plate onto the bolts in the tractor
frame. Install three 3/8" flanged lock nuts and one
5/16" nylock nut onto the bolts.
Tighten.
•
Repeat for the L.H. Side Plate.
HINT:
To help prevent the carriage bolts from spinning,
push against the head of the bolt while tightening to keep
the square neck of the bolt seated in the square hole.
FIGURE 4
RIGHT SIDE VIEW
FIGURE 3
RIGHT SIDE VIEW
3/8" WASHER
SHOULDER
BOLT
3/8" FLANGED
NUT
R.H. SIDE PLATE
LH. SIDE PLATE
STEP 5: (SEE FIGURE 5)
• Remove the two screws in the right side of the plastic
dash housing.
• Attach the on/off switch to the side of the plastic dash
housing, using the two screws.
STEP 6: (SEE FIGURE 5)
FRONT MOUNTED BATTERY ONLY
• Position the wire harness relay box against the front of
the battery tray on the right hand side. Attach it to the
slot in the top of the battery tray with two plastic ties
connected end to end.
• Connect the long black wire on the wire harness to the
negative post on the battery.
• Connect the red wire (with circuit breaker) to the
positive post on the battery.
• Loosely attach the wire harness to the left side of the
battery tray with a plastic tie, keeping it away from the
engine.
FIGURE 5
RIGHT SIDE VIEW
STEP 3: (SEE FIGURE 3)
• Install a hex head shoulder bolt, a 3/8" washer and a
3/8" flanged lock nut in the R.H. and L.H. Side Plates.
STEP 7:
REAR MOUNTED BATTERY ONLY
• Mount the wire harness relay box in front of the
solenoid on the right hand side of the gas tank,
attaching it with a plastic tie.
• Attach the long black wire of the wire harness under
the head of the screw that fastens down the right hand
side of the gas tank.
• Attach the red wire (with circuit breaker) to the rear
solenoid terminal where the battery cable is attached.
• Route the wire harness across to the left side of the
tractor, keeping it away from the engine.
ATTACHING WIRING TO TRACTOR FRAME
RELAY BOX
PLASTIC TIE
(2) PLASTIC TIES
ORIGINAL
SCREWS
RED WIRE
BLACK WIRE
3/8" FLANGED
LOCK NUT
5/16" NYLOCK
NUT
1/2" x 1-1/2"
WASHER
