Husqvarna 395 XP G, Operator'S Manual

Page: 22 / 128

temperature increases above 0°C/32°F. Risk
of too high engine temperature and damage
to the engine.
Heated handles (395 XPG)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (395 XPG)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Daily maintenance Weekly maintenance Monthly maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Clean the cooling system. Refer to
To clean the cooling system on page
33
.
Do a check of the brake band. Refer
to
To do a check of the brake band
on page 23
.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
To do
a check of the throttle trigger and
throttle trigger lockout on page 24 .
Do a check of the starter, starter rope
and return spring.
Do a check of the clutch centre,
clutch drum and clutch spring.
Make sure that there is no damage
on the vibration damping units.
Lubricate the needle bearing. Refer
to
To lubricate the needle bearing on
page 31 .
Clean the spark plug. Refer to
To do
a check of the spark plug on page
27 .
Clean and do a check of the chain
brake. Refer to
To do a check of the
chain brake on page 24To do a
check of the front hand guard and the
chain brake activation on page 23 .
Remove burrs from the edges of the
guide bar. Refer to
To do a check of
the guide bar on page 31 .
Clean the external parts of the carbu-
rettor.
Do a check of the chain catcher. Re-
fer to
To do a check of the chain
catcher on page 24
.
Clean or replace the spark arrestor
mesh on the muffler.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar. Refer to
To do a
check of the guide bar on page 31 .
Clean the carburetor area. Do a check of all cables and connec-
tions.
22 594 - 002 - 08.06.2020