English –
23
Repair instructions
Position puller 504 90 90-02 over the magnets and
counterweight on the flywheel. Tighten 2–3 turns
and tap the head of the puller with a metal mallet to
release the flywheel. Remove the puller, nut and
washer. Lift off the flywheel.
Cleaning and inspection
• Clean all parts, especially the tapers on the
flywheel and shaft.
• Check that the flywheel is not cracked or dam-
aged in any other way.
Replacing the generator, model 357XP/G
and 359/G
1
Remove the cylinder cover. Disconnect the HT lead,
remove the spark plug and fit piston stop 502 54 15-
01 in its place. Take off the starter assembly, release
the leads from the cable guide and remove it.
Remove the cover from the hand grip.
2
Loosen the flywheel nut using a suitable socket
and unscrew it until it is flush with the end of the
shaft.
Position puller 504 90 90-02 over the magnets and
counterweight on the flywheel. Tighten 2–3 turns
and tap the head of the puller with a metal mallet to
release the flywheel. Remove the puller, nut and
washer. Lift off the flywheel.
If replacing the ignition module, disconnect its leads
and unscrew it. The ignition module can be left in
place if you are simply removing the flywheel.
3
Loosen the flywheel nut using a suitable socket and
unscrew it until it is flush with the end of the shaft.
4
2