20
– English
Repair instructions
WARNING!
If the recoil spring is still under
tension when the pulley is re-
moved it can fly out and cause in-
jury. Wear eye protection.
Starter assembly – removal
1
Undo the four bolts that fasten the starter assembly
to the crankcase and lift off the starter assembly.
2
Pull out about 30 cm of the cord and fasten it in the
notch in the pulley rim. Release the tension in the
return spring by letting the pulley wind backwards
slowly.
3
Remove the bolt from the centre of the pulley and
lift off the pulley.
Bolt the vibration damping springs that hold the
tank unit back in place and refit the cover over the
front hand grip.
Tighten to a torque of 4–5 Nm.
3
Run the red lead to the front hand grip and connect
it.
4
Refit the throttle trigger and throttle lock and check
that they work correctly, see ”Throttle lock, throttle
trigger and return spring - removal”.
5
Hand grip heater on model 357XP/G
and 359/G – refitting
1
Feed the leads into the rear hand grip and insert
the heater element in the hand grip. Screw in the
two bolts through the right side of the hand grip to
secure the heater.
2
Press the black lead into the base of the carburet-
tor and connect it with the bolt.
Tighten to a torque of 3–4 Nm.