5
5. BULB REPLACEMENT:
For bulb replacement you will need a small Phillips screwdriver. To replace the H3 12 Volt
100 watt Halogen Spotlight Bulb (See Figure 4A and Figure 4B):
1. Disconnect the Spotlight 2.25 from any charging/power source and lock the spotlight
trigger switch OFF
2. Remove the rubber bezel by pulling it away from the spotlight lens.
3. Remove the two Phillips-head screws that hold the retaining ring to the spotlight body.
4. Pull off the retaining ring and set it aside.
5. Carefully remove the glass lens, rubber “O” ring and reflector assembly.
6. Loosen (no need to fully remove) the phillips-head screw in the neck of the reflector
assembly - this will release the bulb unit.
7. Disconnect the bulb’s center conductor wire from it’s connecting wire (See figure 4B for bulb
removal details).
8. Unsnap the hairpin retaining wires from the reflector’s flange.
9. Using the screwdriver, loosen the retaining screw to remove the bulb from the reflector
(no need to completely remove this screw).
10. Gently pull out the bulb unit and replace with a new H3 12V 100 watt Halogen Bulb
from HUSKY (or minimum H3 12V 55W), available from an electrical supply house or
from HUSKY’s Technical Support Department, call (800) 916-7004.
11. Insert the replacement bulb into the reflector’s flange.
12. Put back and secure the hairpin retaining wires.
13. Connect the bulb power wire to the red power wire.
14. Reverse the above procedure to re-assemble the spotlight.
FIGURE 4A
NOTE:
It is recommended that the unit be returned to Vector for replacement of the spotlight
bulb. Contact HUSKY’s Technical Support Department at (800) 916-7004.
NOTE:
When handling a new halogen bulb, do not touch the glass portion of the bulb.
Natural oils from your hands can cause the bulb to fail. If necessary, clean the bulb with alcohol
or a liquid window cleaner.
RUBBER
BEZEL
RETAINING
RING
GLASS
LENS
RUBBER
O RING
REFLECTOR
PHILLIPS
SCREWS
BATTERY
STATUS
PANEL
