Husky H2G3TK, Operator'S Manual

Page: 20 / 56

20
NAILER/STAPLER
MAINTENANCE
Before each use, lubricate air inlet (E) of the nailer/stapler
(Fig. 13).
If a nail/staple remains jammed inside the tool, comply with
the following procedure:
1) Switch off the compressor.
2) Disconnect the nailer/stapler from the compressor.
3) Release the outer part of cartridge (C) from the locked
position, pressing lever (D) (Fig. 15).
4) Slide the outer part of cartridge (C) downwards (Fig. 16).
5) Using a suitable Allen wrench (G), remove screws (M)
- (N) and (O) located in the top part of the nailer/stapler
(Fig. 20).
6) Remove cover (I) of the nailer/stapler (Fig. 21).
7) Remove the jammed nail/staple.
8) Replace cover (I) of the nailer/stapler.
9) Using a suitable Allen wrench (G), refasten screws (M)
- (N) and (O) to cover (I).
10) Slide the outer part of cartridge (C) upwards, pressing
lever (D) at the same time (Fig. 18).
11) Lock the outer part of cartridge (C), releasing lever (D).
Make sure that the cartridge is firmly secured (Fig. 19).
12) Connect the nailer/stapler to the compressor as
explained at chapter “OPERATION - USING THE AIR
COMPRESSOR”.
13) Once the compressor has been restarted, the
nailer/stapler is ready for use again.
After use, always store the pneumatic tool in a dry, clean
environment. Do not use solvents, flammable or toxic
liquids for cleaning.
WARNING:
FASTENER AND REPLACEMENT PARTS
Use only genuine Husky 18 gauge fasteners (or
equivalent ). Tool performance, safety and durability
could be reduced if improper fasteners are used.
When ordering replacement parts or fasteners, specify
by part number.
TOOL REPAIR
Only qualified personnel should repair the tool, and
they should use genuine Husky replacement parts and
accessories, or parts and accessories which perform
equivalently.
Fig. 20
Fig. 21
Fig. 22
G
N
O
I
A
B
M