Replacing carbon brushes
[Fig.19]
Keep the carbon brushes clean and
free to slip in the holders. When it is
less than 5mm (3/16”) shorter both
carbon brushes should be replaced
at the same time. Use only identical
carbon brushes.
Use a screwdriver to remove the caps.
Take out the worn carbon brushes,
insert the new ones and secure the
brush caps.
To maintain product SAFETY and
RELIABILITY, repairs, any other
maintenance or adjustment should be
performed by Huskie Tools Authorized
or Factory Service Centers, always
using Huskie Tools replacement parts.
VI. MAINTENANCE
• Use only a dry, soft cloth for wiping the
unit. Do not use a damp cloth, thinner,
benzine, or other volatile solvents for
cleaning.
• In the event that the inside of the tool or
battery pack is exposed to water, drain
and allow to dry as soon as possible.
Carefully remove any dust or iron
filings that collect inside the tool. If you
experience any problems operating the
tool, consult with a repair shop.
VII. ACCESSORIES
CAUTION
• The use of any accessories not
specified in this manual may
result in fire, electric shock, or
personal injury. Use recommended
accessories only.
• Your tool is supplied with a guard
for use with a grinding disc. A cut-off
disc can also be used with a cut-off
disc guard.
Grinding Disc
• Rated speed: greater than or equal
to (2834 - 21/32” inch/min)
• Max. wheel diameter:
Φ125mm (4 - 29/32”)
• Hole diameter: Φ22mm (7/8”)
• Max. thickness: 6mm (1/4”)
Grinding Disc Guard
• WHTP-AG
Cut-off Disc
• Rated speed: greater than or equal
to (2834 - 21/32” inch/min)
• Max. wheel diameter:
Φ125mm (4 - 29/32”)
• Hole diameter: Φ22mm (7/8”)
• Flat disc only
Cut-off Disc Guard (For cut-off disc)
• WHTP-AG
Disc Flange
• EY4640K1168
Clamp Nut
• WEY4640K1178
