11
Operator's Manual
26750TSC Compact Tiller
For additional information email
or call 800-345-6007 M-F 8-5
OPERaTION
CONTROlS
DRIVE SaFETY CONTROl lEVER
Engage tines into forward, releasing returns machine to neutral.
Pulling down on drive safety control lever engages the tines.
Releasing the drive safety control lever to a neutral position
disengages the tines.
BElT TENSION aDJUSTmENT
Proper belt tension is critical to good performance. After 1/2 hour
of operation, all cables may have to be adjusted due to initial
stretch. Thereafter, check tension after every 2 hours of operation.
Proper tension is achieved when the spring compresses 1/4”
when drive lever is engaged.
To increase belt tension:
1. Loosen upper jam nut.
SEE FIGURE 7
2. Tighten the lower jam nut in 1/8” increments, making sure not
to over adjust the tension.
3. Check adjustment by measuring spring compression when
drive lever is engaged. (Proper spring compression 1/4”)
4. When proper adjustment is achieved, tighten upper jam nut.
This procedure can be repeated until conduit adjustment bolts
are fully adjusted. If no more adjustment can be made, belt may
need to be replaced.
DRaG STaKE
Tilling depth is controlled by the height of the depth regulator lever.
SEE FIGURE 8
To adjust tilling depth.
1. Remove lock pin.
2. Raise the depth regulator lever to position tines at chosen
tilling depth. Lowering the depth regulator will allow for
deeper tilling.
3. Align hole in depth regulator lever with hole in depth
regulator bracket and replace lock pin.
NOTE: Raise depth regulator all the way when transporting
tiller. Lower the depth regulator all the way to maintain
control of the tiller in harder soil conditions.
drag stake
lever
CaUTION
THIS INFORmaTION IS PROVIDED HERE ONlY TO
INTRODUCE THE CONTROlS. DO NOT STaRT THE
ENGINE aT THIS TImE. STaRTING aND OPERaTING
INSTRUCTIONS aRE GIVEN ON PaGE 11. PlEaSE REaD
THIS SECTION aND all OPERaTING aND SaFETY
INSTRUCTIONS BEFORE STaRTING YOUR TIllER.
•
aS a SaFETY PRECaUTION, THE DRIVE SaFETY
CONTROl lEVER WIll NOT lOCK IN THE FORWaRD
POSITION.
•
TO STOP THE TINES aT aNY TImE RElEaSE THE DRIVE
SaFETY CONTROl lEVER.
WaRNING
ENGINE SHOUlD BE OFF BEFORE aDJUSTING aNY
CONTROlS.
DO NOT aDJUST TIllING DEPTH UNlESS DRIVE
SaFETY CONTROl lEVER IS RElEaSED TO THE
NEUTRal POSITION.
FIGURE 7
FIGURE 8
tension nut
spring
upper jam nut
lower jam nut
forward cable
drive safety control lever
disengaged
