HURAKAN HKN-VRX Series, Manual, Page: 18 / 63

EN
18
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. We recommend that
our agent or qualified technician clean the clean the condenser.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to
your retailer.
Fault Probable Cause Action
The appliance is
not working
The unit is not switch on
Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call your agent or qualified technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call your agent or qualified technician
The appliance
turns on, but the
temperature is
too high/low
Too much ice on the
evaporator
Defrost the appliance
Condenser blocked with dust Call your agent or qualified technician
Doors are not shut properly
Check doors are shut and seals are not
damaged
Appliance is located near a
heat source or air flow to the
condenser is being
interrupted
Move the refrigerator to a more suitable
location
Ambient temperature is too
high Increase ventilation or move appliance to a
cooler position
Unsuitable foodstuffs are
being stored in the appliance Remove any excessive hot foodstuffs or
blockages to the fan
Appliance is overloaded
Reduce the amount of food stored in the
appliance
The appliance is
leaking water
The appliance is not properly
levelled Adjust the screw feet to level the appliance
(If applicable)
The discharge outside is
blocked
Clear the discharge outlet
Movement of water to the
drain is obstructed Clear the floor of the appliance (if
applicable)
The water container is
damaged
Call your agent or qualified technician
The drip tray is over flowing Empty the drip tray(if applicable)
The appliance is
unusually loud
Loose nut/screw Check and tighten all nuts and screws
The appliance has not been
installed in a level or stable
position
Check installation position and change if
necessary