EN
6
1. Brief introduction
This popcorn machine combines the advantages of imported and domestic analogues. It is
made of aluminum alloy and high-strength glass with sprayed inner coating. In addition,
this device is safe to use and saves energy which is suitable for use in restaurants, canteens,
cinemas, etc.
2. Technical specifications
MODEL
HKN-PCORN
HKN-
PCORN2
HKN-PCORN-T
Voltage (V)
220
220
220
Power (kW)
1.3
1.3
1.44
Frequency (Hz)
50
50
50
Dimensions (mm)
500*370*680
560*420*760
940*450*1540
Oil (ml/serve)
50
50
50
Sugar (g/serve)
100
100
100
Corn (g/serve)
150
150
150
Capacity (bowl/min)
1/2
1/2
1/2
3. Attention
a) the machine must be installed on a flat, stable surface;
b) the device must be used with the appropriate power source recommended by the
manufacturer;
c) near the equipment it is necessary to mount the corresponding switches, a fuse box and
a device for fault protection. For ease of use it is not allowed to collect trash;
d) all electrical connections must be installed by qualified electricians.
4. Operation
a) turn on the power switch to turn on the heating tube and light;
b) turn on the boiler switch to preheat the boiler for 5~6 minutes. Pour 50 ml of oil, put
150 g of corns and 100 g of sugar into the boiler, the corns will open with noise.
c) monitor the process of frying the corns, so they are not burned, and close the door
tightly so that the corns do not fly out of the machine.
d) stir the corns until all are open, then pour them out of the bowl;
e) to prepare more popcorn, repeat the cycle 1~5 times. It takes only 2 minutes to make
popcorn.
f) Do not drip oil around the bowl. Otherwise, when heated to a certain temperature, it
may fire;
Attention:
Do not add water to the bowl while frying popcorn!
5. Cleaning and safety measures:
a) disconnect the power and unplug it to avoid accidents during cleaning the machine;
b) to clean the external parts of the machine, use a wet cloth with a neutral agent. Do not
clean the machine under a direct stream of water to avoid short circuit;
d) if the machine is not used for a long time, it is necessary to turn off the power and
unplug it;
e) do not clean the bowl inside with a hard metal brush. Otherwise, the coating may be
damaged.
