EN
7
ATTENTION: THE HEATER SHOULD BE PROPERLY GROUNDED.
NOW THE EQUIPMENT IS READY FOR USE.
3.Use
1.Pour the cold water into the water reservoir.
2.Replace the cover of the equipment.
3.Turn on the equipment. Heating indicator light will illuminate.
4.When left in the tank about three cups of water, turn the switch to the OFF position (off)
and unplug the appliance from the electricity source.
IT is IMPORTANT! upon reaching the boiling point, turn the thermostat control to a value
of 90° c.
4.Wash the appliance after use
1.Thoroughly rinse the tank inside until the full purity. Now the appliance is ready for use
again.
2.Rinse the upper lid by using a non-abrasive cleaning agents, and then carefully wipe it dry
with a soft cloth.
3.The inner part of the tank is made of stainless steel, which can be cleaned with a degreasing
detergent applied onto the sponge.
4.To function properly, the cavity in the middle of the substrate must be free of lime scale.
If necessary, use descaling agents.
5.The faucet can be cleaned with a brush, moving it up and down through the faucet, and
then penetrate inside the appliance through the hole with a brush to clean the faucet
connection. Wash the handle faucet with hot water and SOAP and rinse thoroughly. Then
install the faucet in place.
DO NOT USE baking soda for cleaning equipment, as this may cause discoloration of the
device and corrosion on metal.
5. technical specifications
.
Model
Power
Dimensions
Voltage
Capacity
(l/min)
HKN-HVN10
2000 W
330 × 310 × 420 mm
220 W
50 Hz
10/31
HKN-HVN20
2500 W
370 × 350 × 550 mm
20/48
HKN-HVN30
3000 W
460 × 440 × 440 mm
30/52
HKN-HVN40
3000 W
440 × 460 × 550 mm
40/80