EN
11
When grinding ice, fill the jar with at least 250 ml of water. Otherwise, the blender will
not grind ice.
Fill the jar keeping in mind that the volume of mix will increase in the course of whipping.
Avoid overfilling the jar.
Do not switch on the equipment with an empty jar.
4.
Place the jar into its socket on the motor unit. Make sure the jar is fixed in the operating
position.
ATTENTION! If the jar is installed incorrectly, the equipment will not turn on.
5.
Set the power switch to ON position.
6.
Turn the speed controller to the desired position.
It is always recommended starting the blender at low speed to avoid splashing liquid or
dry ingredients.
Speed can be adjusted during operation without stopping the equipment.
7.
To turn on the pulse mode,
push the PUSH switch.
8.
As the motor rotates at high speed, it is recommended to hold the cover during processing
to prevent the jar from displacing.
9.
If necessary, ingredients can be added into the blender jar during processing. The blender
shall be operated at low speed at that. With the cover on, remove the measuring cap from
it and add ingredients into the opening.
When operating at high speed, and if the blender jar is full or processing hot food, it is
recommended to turn the equipment off before adding ingredients into the jar.
If processing requires adding some ice, add an ice cube at a time with a few second in-
terval.
10.
Hot products and liquids should be processed at low speed only. Do not touch the jar or
cover to avoid burns. Use protective gloves.
11.
If you need to remove the contents from the walls of the jar and mix them, you must first
turn off the equipment. Use a plastic scraper to do that.
ATTENTION! To avoid overheating of the motor when processing solid products and very
thick mixes, the continuous operation of the equipment should not exceed 2 minutes.
Following that, the equipment should be cooled down for at least 2 minutes.
In case of the motor overheating, the protection thermostat will shut down the equip-
ment. In this case, eliminate the overheating cause and let the equipment cool down for
at least 2 minutes. In the event of multiple repeated action of the protective thermostat,
stop the equipment operation and contact the service center.
EQUIPMENT SHUTDOWN
1.
Press the OFF button.
2.
Unplug the power cable.
3.
Take the jar by the knob, remove it from the motor unit and empty it.
MAINTENANCE AND CARE
Turn off the power before any maintenance.
Do not clean the equipment using any abrasive materials, metallic sponges and brushes,
pricking and cutting items, aggressive chlorine-containing cleaning agents, gasoline, acids, al-
kalies and solvents.
