HURAKAN HKN-22S, Manual

Page: 14 / 47

EN
14
5.2 CLEANING THE DEVICE (see fig. 4)
- remove the pusher and tray;
- screw the mincer head nut loose and remove the grate, cutter, spiral conveyor.
Screw it in the direction specified by the arrow.
- screw he mincer head loose and remove it - always in the direction specified by
the arrow.
Now all the parts may be washed (see fig. 5) with warm water (50 ºС) and neutral cleaning
agent.
Use a wet rag to clean the main housing. You should often wash the rag.
Dry cleaning is recommended for the header-grater. Thoroughly clean all the openings.
Make sure that all parts are dry before assembly of the device.
ATTENTION!!! To assemble the meat mincer again perform the following steps:
1) Insert the meat mincer block and fasten it using the switch; ; the switch bush
should be in the opening;
2) Insert the spiral conveyor into the mincer block, make sure that it is in its upper
position;
3) Install the cutter on the square part of the protruding end of the spiral conveyor,
then put the grate on while preserving the original coupling;
4) Upon assembly of all the parts, tighten the meat mincer nut.
Figure 4 - Disassembly of the device
Figure 5 -Disassembly of the device for cleaning