CARE
11
Removing the Shade (If Necessary)
■
Start at the bottom of the front channel, pull the channel to separate from the mounting
channel.
■
Repeat for the opposite side.
■
Lower the shade approximately 4".
■
While holding the headrail, push
back on the bottom tab of the
installation bracket with a
flat blade screwdriver to release
the bottom edge of the headrail.
■
After releasing the bottom edge,
roll the back of the headrail
down and out from the bracket.
Removing the Bottom and Rear Channels (If Necessary)
■
After removing the front channels and the shade, remove the bottom channel.
➤
If you used the screws to attach the bottom rail to the sill, remove the bottom channel
cover and remove the screws.
➤
If you used the adhesive tape to attach the bottom channel, insert a putty knife
between the bottom channel and the sill to pry off.
NOTE:
You may need a solvent like 3M
™
Citrus Base Cleaner and/or Isopropyl alcohol
to remove the adhesive residue from the sill.
Headrail
Bracket
Back of
Shade
Remove
Bottom
Tab
