26
®
SmartPort
®
Wiring Harness…
Preparing the Communication Port
To utilize the SRR Remote Control
System, your Hunter controller must be
equipped with the SRR SmartPort
®
wiring
harness. This wiring harness provides
the communication port where the SRR
receiver is attached. The SmartPort
®
installation instructions are included in
the Pro-C installation and programming
instructions. Additional wiring harnesses
can be purchased separately to allow you
to utilize the transmitter and receiver with
additional controllers.
Installing the SRR Remote Wiring
Harness…
1) Install a 1⁄2" female threaded “Tee” in
the field wiring conduit approximately
12” below the Pro-C controller. (Note:
the harness may be installed out doors
by first bringing the conduit through an
exterior wall, then installing the appro-
priate fitting).
2) Feed the red, white and blue wires of
the harness through the base of the
“Tee” and into the controller wiring
compartment as shown in Figure 1.
3) Screw the harness housing into the
“Tee” (or other fitting) as shown in
Figure 1.
4) Attach the red,
white and blue
wires from the har-
ness to the terminal
block of the con-
troller as shown in
Figure 2.
Extending the Wiring
Harness…
Any extension of the wiring on the
harness may result in an error message
in the controller display and possible
malfunction of the remote unit due to
radio interference. In some situations,
lengthening of the harness may work fine,
in others it may not work at all (it is
site specific). In either case, extending
the wiring harness should be done using
shielded cable (Radio Shack P/N 278-513)
to minimize the possible effects of
electrical noise. See diagram below.
Proper Extension of Wiring Harness
Using Shielded Cable…
Transmitter…
Preparing the Transmitter for Use
Your SRR System is designed to work
right out of the box. This means that other
than installing the battery, you may chose
to skip this entire section. However, we
recommend you read it because with a few
simple steps you can customize your SRR
to add functionality and security to your
system. Be aware that if you change your
transmitter address or maximum station
number as described below, you should
INSTALLATION AND PROGRAMMING
Fig. 1
To Controller
1⁄2" Thread
Pre-assembled
Wiring Harness
Fig. 2
Red
Blue
White
RADIO SHACK SHIELDED
CABLE PN 278-513
PRO-C TERMINAL BLOCK
GRD
AC1
AC2
REM
SEN
SEN
Summary of Contents for Pro-C
Page 35: ......
