8
1886
1886
Installing the Bulbs and Glass
ON
Turn P
ow
er
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Bulbs/Glass
Wall Control
Install the included LED
bulb into the socket. When
necessary, replace with
bulb of same wattage.
Lift the glass and attach
it to the light fixture using
the three thumbscrews.
Tighten all three screws
securely by hand.
NOTE: Check to ensure
proper engagement.
Assembling the LIght Kit
Partially install two light kit assembly
screws, found in the
hardware
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
2 of 6
Light Kit Screw
bag
Install the three switch housing screws, found in
the
hardware bag. Tighten all three screws.
3 of 6
Light Kit Screw
bag
Connect the plugs from the upper and lower
switch housings. Make sure to line up the colored
markings on the connectors. Lift the lower switch
housing until its screw holes are aligned with the
screw holes in the upper switch housing.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
1 of 6
Light Kit Screw
bag
