8
1886
1886
Installing the Glass
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Glass
Pull Chain
Fan style may vary.
Note:
Assembling the Light Kit
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
2 of 3
Light Kit Screw
bag
Fan style may vary.
Note:
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
3 of 3
Short Light Kit
Screw
bag
Turn the light kit counterclockwise until the light
kit screws are firmly situated in the narrow end of
the keyhole slots. Install the third screw
and
tighten all three screws securely.
Partially install two of the light kit screws found
in
the bag. It does not matter which two
screw holes you choose. Connect the plugs from
the upper switch housing and the LED assembly.
Make sure to line up the colored markings on
the connectors.
Installing the Blades:
2 of 2
Thumbscrews
bag
ON
Turn P
ow
er
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
Lift glass assembly and align the two exposed glass
assembly holes with two holes in the upper switch housing.
Attach with thumbscrews found in the hardware bag.
Tighten all four thumbscrews.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
Feed the wire plugs through the center
hole of the upper switch housing, then
wrap keyhole slots around the screws
and twist counterclockwise.
1 of 3
Light Kit Screw
bag
