4
1886
1886
Check the outlet box:
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64” pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the hardware bag.
Option 2:
Wood Screws
OFF
Turn P
ow
er
Do this first!
The machine screws are the ones
that came with your outlet box.
Hunter Pro Tip:
You have
two options
for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation.
Only use the provided Hunter ceiling bracket that came in your fan’s box.
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Glass
Pull Chain
Installing the Ceiling Bracket
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
2
PB
1886
1886
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
Pass all wires to one side of horizontal bar in
downrod assembly. Hand tighten the downrod
(at least 4–5 full turns) until it stops. Trim the
wires coming from the fan so that 8-inches
remain coming from the top of the downrod.
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
Hunter Pro Tip:
The adapter cover is not used for
low-profi le mounting.
Installing the Downrod
Tighten the setscrew
with pliers.
DO NOT
HAND TIGHTEN.
FAN FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH:
• ALWAYS
tighten setscrew with pliers.
• DO NOT
hand tighten setscrew.
• CHECK
the setscrew is tight using pliers
each time you change fan direction.
Lower the adapter cover until it rests fl ush
against the motor housing.
Fan style may vary.
Note:
KEEP!
Back out the pre-installed setscrew
so that the setscrew’s threads
are still engaged while the shank
does not protrude and obstruct the
insertion of the downrod.
DO NOT
REMOVE
SETSCREW
COMPLETELY
8”
3/8”
C
U
T
&
ST
R
IP
(not t
o scale)
DR-01 r061622
Use machine screws
(provided with
outlet box)
and washers when securing
to existing ceiling fan-rated outlet box.
Make sure it is securely installed and
is acceptable for fan support of 31.8 kg
(70 lbs) or less.
Option 1:
Machine Screws
For angled ceilings,
point opening
toward peak.
ANGLED
MOUNTING TIP
Washer
x2
bag
Wood Screw
x2
