6
Hunter Fan Company
42503-01 • 02/08/06
7
42503-01 • 02/08/06
Hunter Fan Compan
Steps 3-9 – 3-10
Low Profile
Screw
Low Profile Washer
WARNING:
Fan may fall if not assembled as directed in these
installation instructions.
You can assemble your fan for
standard
or
angle
mounting as shown
in steps 3-1 – 3-4 on the previous page. For
low profile
mounting
(ceilings less than 8 feet high), see steps 3-5 – 3-11 on this page.
For Low Profile Mounting:
Note:
For low profile mounting, the downrod is replaced with the low
profile washer.
3-5. Unbundle the wires from the fan.
3-6. Remove the screw from the hanger ball on the downrod, and
then remove the hook from the hanger ball.
CAUTION:
e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-7. Remove the set screw from the adapter.
3-8. Install the hook and two neoprene washers onto the adapter
using the set screw. the top of the hook must hang over the
adapter.
Note:
e screw should be tight, but still allow the hook
to rotate slightly.
3-9. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
3-10. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
3-11. Raise the fan and place the hook on the adapter through the
loop on the ceiling plate.
Step 3-6
Step 3-8
Step 3-11
Downrod
with Hook
Loop
3 • Assembling and Hanging the Fan (Low Profile Only)
