6
Hunter Fan Company
42503-01 • 02/08/06
7
42503-01 • 02/08/06
Hunter Fan Compan
3 • Assembling and Hanging the Fan
Steps 3-1 – 3-2
Downrod
Canopy
Canopy
Trim Ring
Set Screw
WARNING:
Fan may fall if not assembled as directed in these
installation instructions.
You can assemble your fan for
standard
or
angle
mounting as shown
in steps 3-1 – 3-4. For
low profile
mounting (ceilings less than 8 feet
high), go to steps 3-5 – 3-11 on the next page.
For Standard or Angled Mounting:
3-1. Unbundle the wires from the fan.
3-2. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly.
Note:
When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
CAUTION:
e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-4. Raise the fan and place the hook on the downrod through the
loop on the ceiling plate. e arrows on the downrod and on the
ceiling plate should both be pointing towards the tab hole on the
canopy. Go to
4 • Wiring the Fan
.
Step 3-4
Downrod
with Hook
Loop
