©2012 Hunter Fan Company
Ceramic End
REPLACING THE UVC BULB:
Maintenance (continued)
Follow these instructions to remove and replace the
UVC
bulb.
1. Unplug the unit from the wall outlet.
2. Remove the r
ear grill on the back of the unit by
gently pulling the
removal tabs away from the unit
and lift the r
ear grill away. Figure 7.
3. Remove the HEPA
filter. Figure 9.
4. Using a small Phillips screwdriver remove the four
mounting screws holding the UVC Cover in place.
Figure 11.
5. Remove the two black
insulators covering each
end of the the
bulb. Figure 12.
6. Grasping the two
ceramic ends of the UVC bulb,
twist
bulb approximately one-quarter turn in either
direction to allow the pins to lineup with the
exit
groove and allowing the bulb to be removed.
Figure 13.
7. Remove the new UVC
bulb from its packaging
being careful not to let the
bulb come in contact
with your skin.
Note:
Oils from your skin can cause damage to the
bulb and will prevent it from working.
8. Using the bag the
bulb came in, to prevent skin
contact with the bulb, insert the new UVC
bulb
into the
bulb mounts. Figure 13. Once the bulb is
pressed firmly into the mounts at both ends, twist
the
bulb approximately one-quarter turn in either
direction until
bulb is secured. Discard the bag.
9. Note:
If the UVC
bulb is not reinstalled correctly,
the unit will not run.
10. Reinstall the two black
insulators. Figure 12.
11. BE SURE to reinstall the
UVC cover using the four
mounting screws. Figure 14.
12. Replace the HEPA
filter (see page 8).
13. Replace the
rear grill.
Figure 11
Figure 12
Figure 13
Figure 14
Mounting
Screw
Mounting
Screw
Insulator
Exit Groove
Bulb Mount
Bulb
UVC Cover
UVC
Cover
9
Max 3.5W
Bulb
©2012 Hunter Fan Company
