5
®
™
AQUA DC V2 CEILING FAN CONTROL MODULE
AND HANDSET PROGRAMMING EXPLANATION
*HANDSET PROGRAMMING ONLY NEEDED WHEN GETTING NEW HANDSET
MAKE SURE THE ISOLATION SWITCH IS ON OR REMOTE CONTROL WILL NOT WORK
Handset Battery Installation/Replacement
Open the battery compartment by pushing the cover away from you. UNWRAP THE PLASTIC
FROM AROUND NEW BATTERIES (if wrapped). Observe polarity and make sure battery sits
properly in recess. Slide the cover back into place.
How To Add a Replacement Handset
The receiver can learn the identification code for a new handset using the following procedure:
A.
Turn off power to fan at isolation / wall switch and wait for 30 seconds then turn power
back on, the fan will beep once.
B.
Press and hold the
“
Forward/Reverse
”
button for 5 seconds until the fan beeps once.
The remote will then be linked to the fan. Two handsets can be used with each fan,
and the same handset can be control multiple fans.
How To Add an accessory 240V DC Wall Controller (sold separately )
The receiver can learn the identification code for a new DC wall controller using the following
procedure:
A.
Turn off power to fan at isolation / wall switch and wait for 30 seconds then turn power
back on, the fan will beep once.
B.
Press and hold the
“
Forward/Reverse
”
button for 5 seconds until the fan beeps once.
The DC Wall Controller will then be linked to the fan. Either two remote handsets or
one remote handset combined with one DC Wall Controller can be paired per fan and
can control a maximum of two ceiling fans.
* Please note maximum two ceiling fans using one DC wall controller. Both fans must have their
own receiver and the wall controller must be installed in the same room as the fans.
*
If the 240V DC Wall Controller is fitted, there will only be 6 speeds and 6 settings of dimming
available. No LED colour changing available via the 240V DC Wall Controller, this is only via the
remote handset. The 9 speed handset will still have all the functions.
NOTE:
THE MAINS POWER TO THE CONTROL MODULE MUST BE SWITCHED ON
-
OFF VIA AN ISOLATION SWITCH.
NOT
THE BUTTONS ON THE HANDSET.
SEE TERMS AND CONDITIONS OF WARRANTY. YOU WILL BE CHARGED A SERVICE FEE
IF THE PRODUCT IS NOT DEFECTIVE OR IS DAMAGED BY POWER SURGES, LIGHTNING,
WEATHER, MISUSE/ABUSE AND SIMILAR SITUATIONS
.
ALL INSTALLATION
INSTRUCTIONS MUST BE FOLLOWED.
Installation & User
Manual
1.
Do not
attempt to operate the fan or light (if fitted) with any wall control that is not approved by
Hunter Pacific for use with its fans. DO NOT use solid state controllers. The use of unapproved
controllers may void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of the fan. If only
one blade is damaged you are still required to replace with a new set.
