Hunter Marine HUNTER 25, Owner'S Manual

Page: 47 / 128

Mast Assembly
____ Review manufacturers manual for maintenance and up-keep
____ Spreaders securely fastened
____ Mast and spreaders free of corrosion and stress cracks
____ Standing rigging and pins inspected for wear, tear, corrosion and cracking
____ External wiring secured for anchor, steaming and deck lights
____ Electronic wind indicator installed per manufacturers recommendation
____ Manual wind indicator installed on masthead
____ VHF antenna installed and connected
____ Headsail furling system installed inspected per manufacturers recommendation
____ Running rigging inspected for wear and tear
____ Mast step stand-up blocks secured and operational
____ Main Sail, jib sail and flaking system inspected for wear and tear (non-furling mast). In-mast
system checked for smooth operation and overall condition of sails
____ Specified pre-bend and diagonal tensions attained in mast. See owners manual
____ Mast to deck wiring properly sealed with drip loop
Anchor System and Ground Tackle
____ Anchor windlass inspected per manufacturers recommendation
____ Anchor secured in bow roller assembly
____ Spare anchor onboard and accessible. See Chapman’s Manual for recommendations on
anchors, anchor lines and drogues
____ Anchor line pays out and retrieves into anchor locker without difficulty
____ Bitter end of anchor line secured
____ Anchor rode inspected and free of abrasions
____ Anchor chain shackle lock-wired at pin after secured to anchor and corrosion free
____ Anchor locker hatch secures properly with anchor and line in place
____ Anchor locker free of debris inside
____ Anchor locker drains open
Fuel System
____ Tank fuel level indicator functioning properly
____ Fuel clean and treated with engine manufacturers recommended additives
____ Primary and secondary filters cleaned or replaced
____ Fuel tank supply valves open
____ Fuel tank vent clear from tank to atmosphere (hose has anti-siphoned loop in place at
hull or deck side)
Steering System
____ Inspect and service steering system according to manufacturer’s recommendation
____ Clean and grease autopilot drive chains
____ Ensure compass light is operational
PAGE 13A- 3