9
Operation/Troubleshooting
OPERATION
Attach the Magnetic Hold-Down Brackets (Optional)
Lower the shading, keeping the vanes closed.
Place the magnetic hold-down bracket onto the bottom rail just inside
the end cap, oriented as shown.
Hold the bracket while opening and closing the vanes. (It may be
necessary to have someone assist you.) Adjust the bracket to the best
overall position.
Mark the screw location using the mounting options shown below.
The screw should be placed in the middle of the channel. This will
allow for adjustment.
Drill the screw holes using a
3
/
32
" drill bit.
IMPORTANT:
Use drywall anchors when mounting into drywall.
Attach the hold-down brackets to the mounting surface using
the screws provided.
If necessary, adjust bracket height by loosening the screw and
sliding the bracket up or down.
Hold-Down
Bracket
Bottom
Rail
Outside Mount
Preferred
Alternate
Inside Mount
Preferred
Alternate
Adjust bracket
height by
loosening the
screw and sliding
the bracket up or
down.
Operate the Shade
Beaded Chain Operation
To Lower The Shade
Hold the back of the beaded chain loop and pull down.
Pull until the shade is at the desired height.
To Raise The Shade
Hold the front of the beaded chain loop and pull down.
Pull until the shade is at the desired height.
Cordless Operation
To Lower The Shade
Pull down on the tassel until the shade is at the desired height
To Raise The Shade
Gently pull down on the tassel. To raise the shade completely, simply release the tassel and the
shade will roll up fully into the headrail. To raise the shade partially, when the shade is at the
desire height, gently pull on the tassel to stop the shade from raising.
Remove the Shade
Push the front of the horizontal shading and then bring forward.
