1
532505-3_A
PORTABLE TRANSDUCER Installation Guide
Use the instructions in this guide to install the portable transducer.
NOTE:
The procedures and features described in this guide are subject to change without notice. This guide was written in English and may
have been translated to another language. Humminbird® is not responsible for incorrect translations or discrepancies between documents.
NOTE:
The illustrations in this guide may not look the same as your product, but your unit will function in the same way.
Installation Preparation
Install the control head before you start the transducer installation
. See the control head installation guide.
Read the instructions in this transducer guide completely
to understand the mounting guidelines before beginning the
installation.
Supplies:
In addition to the hardware supplied with your accessory, you will need a Phillips-head screwdriver. If you are installing
the Speed Sensor Accessory, you will need the Sonar/Speed Y-Cable. Contact Humminbird Technical Support for details.
Visit our Web site at humminbird.com
for additional information and resources for transducer installations. Also, visit
youtube.com/humminbirdtv
for informational videos.
Confirm your boat is level for the installation.
Preparation
1
|
Test the Transducer Prior to Installation
Prior to installation, test the transducer to make sure that no damage occurred during shipping.
1. Confirm the control head is connected to power. See your control head installation guide for instructions.
2. Connect the transducer cable to the control head. See
Connect the Transducer Cable
.
3. Lower the transducer into the water.
WARNING!
The transducer must be fully submerged in water during operation because the sonar signal cannot pass through air. Air
pinging can damage the transducer.
4.
Power On:
Press the POWER key to turn on the control head.
If the transducer is detected, the control head will start Normal mode.
5. Select a 2D Sonar View to display on-screen.
If the bottom is visible on-screen with a digital depth readout, the transducer is working properly.
6.
Power Off:
Press and hold the POWER key.
7. Remove the transducer from the water.
8. Disconnect the transducer cable from the control head.
2
|
Assemble the Transducer Mounting Bracket
NOTE:
Please be aware that the transducer design has changed. If you are replacing or adding mounting hardware to your current transducer,
make sure that you have selected the appropriate hardware. If you are replacing a transducer, you will need to replace the mounting bracket
and hardware. Contact Humminbird Technical Support for details.
Use the illustrations in the section below to find your mounting bracket and assemble the portable transducer bracket.
