PiranhaMAX™ In-Dash Mounting Kit
2
532463-1_B
5.
Test the Mounting Hole:
Install the control head in the mounting hole to test the fit. Make adjustments
to the mounting hole as needed. Remove the template when finished.
6. Thoroughly clean and deburr the mounting hole.
3. Install the Control Head
1. Insert and tighten the two threaded rods into the two threaded inserts located on the back side of the
control head. See the illustration
Inserting the Threaded Rods
.
2. From the front side of the dashboard, insert the control head through the mounting hole.
3. Press down lightly on the control head. Confirm the control head is centered and flush against the
dashboard. Make adjustments as needed.
4. From the back side of the dashboard, slide the bracket holes over the threaded rods. Install a nut onto
each threaded rod and hand-tighten until it is fully secure.
Hand-tighten only!
See the illustration
Assembling the Bracket
.
5. Insert the cables into the ports on the back of the control head. The ports are keyed to prevent reverse
installation, so be careful not to force the connectors into the wrong port.
CAUTION!
Do NOT mount the cables where the connectors could be submerged in water or flooded. If cables
are installed in a splash-prone area, it may be helpful to apply dielectric grease to the inside of the connectors to
prevent corrosion. Dielectric grease can be purchased separately from a general hardware or automotive store.
Inserting the Cables
Inserting the Threaded Rods
threaded rod
dashboard
(partial view)
Assembling the Bracket
bracket
nut with
lock washer
side closest
to bracket
