NOTE:
When the LED is set to ON it will flash every four seconds when the RSS is in operation (i.e. when the wet switch is submerged). Even when the LED is set to ON, the LED will not
flash unless the wet switch is activated. If you want to test the RSS to make sure the LED is set to ON before using the RSS, wet your finger and hold it on the wet switch; if the LED is set
to ON, the LED will begin to flash.
NOTE:
Repeat steps 1 and 2 to turn off the LED when finished with night fishing.
3. Once you have made your selection you can either wait 20 seconds for programming mode to time out (the Start-Up screen will appear on the Control
Head display), or continue immediately to the next procedure to change the channel.
Changing the Channel on the Advanced RSS
To change the channel type on the Advanced RSS:
1. From the Light programming mode (see Turning on the Advanced RSS Blinking Light), touch and release the wet switch contacts twice more with your
moist finger to change from the Light programming mode to the Channel programming mode. The temperature reading on the Control Head will change
to show a temperature reading of 50°F (9°C) (channel set to A).
2. To change the setting to 55°F (12°C) (channel set to B) touch and release the wet switch contacts once more. Wait two seconds and then confirm
that the temperature reading on the Control Head has changed to 55°F (12°C). Single touches will toggle the setting between 50°F (9°C) and 55°F
(12°C).
3. Once you have made your selection, wait 20 seconds for programming mode to time out (the Start-Up screen will appear on the Control Head).
5. Use the SetUp Channel Select menu on the PiranhaMax Control Head to switch the software to match the new channel designation on the Advanced
RSS. See Channel Select (SetUp Menu) for more information.
CAUTION:
Make sure that you change the Channel Selection on the Control Head to match the new Advanced RSS Channel before using the Advanced RSS.
Temperature of 50 Means Channel is Set to A
Temperature of 55 Means Channel is Set to B
Temperature of 40 Means LED is OFF
Temperature Setting of 45 Means LED is On