3.
Connecting the Transducer Cable
This section covers how to connect your transducer cable to your control head.
NOTE:
If you have an ICE 55 Flasher, remove the control head and base from the portable
bag first.
1. Insert the transducer cable into the appropriate terminal slot on the rear of the
control head.
NOTE:
The slots are keyed to prevent reversed installation, so be careful not to force the
connector onto the holder. If the cable connector feels tight, lightly coat the outside of the
connector with silicone grease.
2. Route the transducer signal cable beneath the control head and secure to cable
clips on the base.
3. Reinstall assembled control head, base, and transducer into portable bag
(ICE 55 only).
Connecting to the ICE Flasher Series™ Fishfinder
Lightly coat
the outside
of the
connector
with silicone
grease.
Transducer
Signal Cable
Cable
Clips
14
