16/22
User Manual COMBILYZER Plus
4.6.2
Sending data to Host Computer
In the Memory/Send submenu it is possible to send records from the memory to
a host computer. The selected range of measurement data (located in the
selected range of memory addresses) will be sent to the receiver serial port at
the pre-programmed speed. Refer to section 4.6.1. for details about setting the
memory range to be sent. For setting the parameters of the serial port see
section 4.2.2.
Note: Entering a new patient ID or modifying an existing one for a selected
memory record is possible both in the Memory/Print and Memory/Send
submenus with the Set-ID function button.
4.6.3
Enter Patient ID for Memory Record
New patient IDs can be entered or a existing IDs modified. Enter the
Memory/Print or the Memory/Send submenu and choose a data record by
adjusting the low limit of the memory range (see figure 10). After pressing the Set
ID button, a new patient ID for the selected record can be set or an existing ID
can be modified. Use the key pad to enter the patient ID and store it by pressing
the OK button.
4.6.4
Clearing Test Data from Memory
All data in the memory, or only a specific record, can be deleted in the
Memory/Clear submenu. The maximum number of stored records is 200. The
lower and upper limits of the memory address can be set by using the UP and
DOWN arrows in top-right corner of the LCD (refer section 4.6.1. for details about
setting the memory range to be cleared). After setting the limits of the memory
range that should be erased, press the CLEAR button. The address pointer
returns to the next lower address field after execution of the memory clear
function. By pressing CLR.ALL button all, existing records in the memory will be
cleared.
