Please send any questions or comments regarding these instructions to: [email protected]
© 2008 Human Touch®, LLC.
INSTALLING THE NEW BACKREST ACTUATOR
1. Align the new actuator with the front and rear mounting points, then secure it by replacing the front and rear hinge pins.
2. Using a needle-nosed pliers, replace the C-clamps on both hinge pins to secure them.
3. Connect the new actuator cable connector to the corresponding connector on the chair base.
4. Position the connectors inside the junction box base, place the junction box cover onto the base, then secure it using two screws.
5. Plug in the chair, power it on, and verify that the recline function is now working properly.
6. Locate the front hinge pin, then, using a needle-nosed pliers, remove the C-clamp that secures the hinge pin to the chair (Fig.3).
7. Using a pliers, remove the front hinge pin.
8. Locate the rear hinge pin, then, using a needle-nosed pliers, remove the C-clamp that secures the hinge pin to the chair (Fig.3).
9. Using a pliers, remove the rear hinge pin.
10. Remove the backrest actuator from the chair.
(Fig.3)
Front hinge pin
C-clamp
Rear hinge pin
C-clamp
Backrest actuator
