S A F E T Y I N S T R U C T I O N S
4
Safety instructions
en010501_sc.FM
Safety instructions
This page describes important safety instructions, which
the operator’s of Hultdins SuperFell, SuperSaw and
SuperCut attachments should have a good knowledge of
before the equipment is used.
This manual should be available at all times so that the
operator is able to follow safety regulations and the
procedures of maintenance activities..
Note!
Read carefully and understand the following
information with concerns to safe operation practices
before operating this equipment.
Important!
The owner and the operator are responsible for
following all safety regulations and that the machine
is safely equipped.
Important!
Check the machine for damages at the beginning of
each shift.
Important!
Inspect and lubricate the unit at the beginning of each
shift. Tighten all fasteners regularly.
Important!
All service and repairs should be carried out by
qualified personnel or an authorized repair shop with
suitable tools and lifting devices.
Important!
When working on the saw chain always ensure the
engine is shut off and wear safety gloves to prevent
injuries. Remove the saw chain when making any
adjustments or servicing the saw unit.
Important!
Never adjust any hydraulic pressures without using a
pressure gauge.
Important!
Consider the environment. Plug all connections to
avoid unnecessary spill of oil.
Warning!
The hydraulic input of the equipment must not
exceed the recommended maximum rating as
structural failure could occur, resulting in injury and
damaged equipment.
Warning!
Before performing any maintenance or service work,
lower the attachment to the ground and shut off the
engine. Turn off any master shut-offs and do not
allow personnel in the cab.
Warning!
Keep all windows and doors securly closed when
operating.
Warning!
Never touch or stand close to the pressurized
cylinders and hydraulic hoses.
Warning!
The attachment has sharp edges. Use proper
wrenches and protective gloves when working on the
attachment.
Fig. 1
The operating area of the saw attachment and the
recommended safety distance
90 meters/300 feet
Warning!
When operating this equipment ensure all other
personnel remain at least 90 meters (300 feet) clear
of the machine. Turn the machine off immediately if
anyone enters this safety zone.
Warning!
Training or demonstration of this equipment should
be performed from an operator´s cab approved by
national regulations. Observers should always
remain at least 90 meters (300 feet away).
Warning!
Always use High Speed saw chains with 3/4” pitch
saw units.
