P R O C E D U R E S
30
SuperCut
en011106c_sc300.FM
Procedures
Replacing bar holder
When replacing the bar holder, always use the following
method.
1.
Place the unit steady on the ground with the saw unit
facing up (when possible).
2.
Remove the saw chain.
See Replacing saw chain
.
3.
Remove the saw bar.
See Replacing saw bar
.
4.
Disassemble the guide screws (1) and remove the bar
holder (2) from the tension device.
Important!
Never start the machine with the bar holder removed.
5.
Inspect and clean the grooves (3) from any debris.
6.
Install the bar holder (2) into the tension device. Fit
the guide screws (1) into the grooves (3) and tighten
the guide screws (1). Torque 20 Nm
7.
Install the saw bar.
See Replacing saw bar
.
8.
Install the saw chain.
See Replacing saw chain
.
1
2
3
