F U N K T I O N A L D E S C R I P T I O N
18
SuperCut 100
En010905a_sc100.FM
Funktional description
SuperCut 100
The
SuperCut 100
is made up of one Saw stand (1) which
contains a 4-point bearing with a gear drive, a feed out
cylinder (5) with integrated rack and proportional lubrication oil
pump (6). The feed out cylinder (5) is equipped with hydraulic
dampening for “Soft Stop” to eliminate shock loads. The piston
stops the hydraulic flow by passing the entry hole (A) in the
connection flange (7).
The
SuperCut 100
can be supplied with different saw motors ,
from 10cc to 32cc (4).
The
SuperCut 100
is equipped with a patented automatic chain
tension system, made up of a tensioning device (2) on which the
bar holder (3) is attached.
Optional accessories such as cut-control devices (8) are easy to
install.
The feed out cylinder (5) and the bar holder (3) are not on the
same level, which eliminates problems with snow packing or
other debris. The saw bar feed out angle (B) is 95°.
The tension device(2) can easily be relocated in 9.23° steps for
various “saw bar starting” angles, to accommodate specific
attachment design requirements.
The
SuperCut 100
is can be equipped with .404” pitch saw
chains with saw bars up to 90cm, or with 3/4” pitch saw chains
with saw bars up to 67,5cm.
Fig. 11
Huvudkomponenter SuperCut 100
1.
Housing with integrated 4-point bearing/gear drive
2.
Tension device
3.
Bar holder
4.
Saw motor
5.
Saw bar feed out cylinder with rack
6.
Lubrication oil pump
7.
Connection flange
8.
Cut control
1
2
3
4
5
6
7
8
A
