CSB 229
14
Installing PES 5000 version 3 includes setting Inroute 32 to F7FF
PES 5000 version 3, in a manner similar to other recent PES products, can operate in conjunction with disaster recovery
software at the Hub. This disaster recovery software aids the remotes with repointing in the event of a satellite failure by
allowing the remote indoor unit to display an antenna pointing voltage. When disaster recovery software is present at the
Hub, it is necessary to enter inroute 32 as F7FF in order to conduct ranging without displaying the antenna pointing
voltage on the indoor unit. When disaster recovery software is not present at the Hub, entering inroute 32 as F7FF has no
effect. Therefore, during installation always enter inroute 32 as F7FF.
Figure 10 summarizes the installation process for PES 5000 version 3. The PC display 5/J. lasts for approximately 3 to 4
seconds and signifies that Hub has disaster recovery software and that inroute 32 has been properly entered as F7FF.
Refer to CSB 219 for additional information regarding site commissioning with disaster recovery software at the Hub.
Install Hardware
Configure Remote Parameters
Set dialog-> ranging-> initial timing offset
Set dialog-> network->Inroute 32
to installation value (F7FF)
Write parameters. Set install mode.
Aim antenna
Remote resets.
IF display = 1 PC display = 5/J.
Wait for ranging (commissioning) to complete.
Success,
PC display = 3/b.
Timeout,
PC display = 3/U.
Dialog, set initial timing offset to ranged timing offset.
Leave initial power level at 80.
Put remote in Normal mode.
Remote resets.
IF display = 1 PC display = 5/J.
Use latlong to get timing offset (ticks)
Put remote in COMM (commissioning) mode.
00W0085.FH8
= DIU Configuration Editor Step
Figure 10 Enter Inroute 32 as F7FF during PES 5000 version 3 installation
Summary of Contents for PES 5000
Page 17: ...CSB 229 17 ...