Chapter 2 • Antenna parts and required tools
14
1037751-0001 Revision A
Tools
Table 2 lists the tools required to assemble and install the
antenna.
Table 2: Tools and additional materials required to assemble and
install the antenna
Tool or material
Details
Socket wrench, ½-inch
For 5/16-inch bolts.
2 open-end wrenches,
½-inch
For 5/16-inch bolts. Two of the Az/El
canister nuts are not accessible with a
socket wrench and therefore require the
use of an open-end wrench. Some nuts
and bolts require a second wrench to
prevent turning.
Torque wrench
With 5/16-inch sockets capable of torquing
to 8 ft-lb.
Long-shaft hexagonal
Allen wrench, 7/64-inch
For Allen screws with a 7/64-inch
hexagonal socket. Driver shaft should be at
least 5 inches long.
Torque wrench for
hexagonal socket
Must fit a 7/64-inch hexagonal socket and
be capable of torquing to 15 in-lb.
Bubble level
Used to make sure that the mast is plumb.
Compass
Used in determining antenna azimuth.
Pencil
Carpenter’s pencil.
Weather grade silicon
sealant
Used to keep moisture away from cable
connections.
Weatherproofing tape
Used to keep moisture away from cable
connections.
Approved RG6 cable
Used for IFL between satellite modem and
antenna.
UV-rated cable ties
Used to secure slack in cables to antenna
mast.
Summary of Contents for HughesNet AN8-074R
