4
1041317-0001 Revision D
It is very important to make sure that all connections are tight. The DC IN
power connector must be seated correctly with no gaps as seen below.
The HT2000W power cord connector uses a locking mechanism to ensure it
stays snugly connected to the modem. Make sure the connector is oriented
correctly when plugging it into the DC IN port;
the flat side of the plug should
face the modem’s side panel nearest to the port.
Figure 3
shows the correct position of the power cord connector. When
connecting the power cord, you must push the connector into the DC IN port.
This creates a locking connection between the power cord and the modem.
Figure 3: Aligning the power cord connector
It is
not recommended
that you attempt to disconnect the power cord from
the modem, unless instructed to do so by Customer Care.
If you need to turn off or power cycle the modem, simply unplug the cord from
the electrical outlet.
3.
Plug the power supply into the surge protector or directly into the power
outlet.
Wait for the modem to become operational
When you plug in the power supply, the new modem begins an automatic
installation process. Some of the white indicator lights on the modem’s front
panel blink on and off.
Wait approximately 60 minutes for installation to complete.
During this time you will not be able to use the Internet.
Do not unplug the modem power cord during installation.
Flat
side of
plug
