Hughes HN9000, Installation Manual

Page: 80 / 126

Information about selected parameters
This section provides information for selected parameters on the Terminal Status page. Parameters that may be most
useful for you to know about are listed.
The Dial Backup Status parameter and Dial Backup Status category of parameters do not apply to the HN9000 satellite
modem.
System Information page
The System Information page shown in Figure 44: Terminal Status page (top part) on page 66 provides system
information for the satellite modem such as ST name (modem name), Site ID (Site Id), and operational software version.
Figure 45: System Information page (top part)
Note: Print the System Information page and tell the customer to save it. The customer might need it if they cannot
access the System Control Center and they need to call Hughes Customer Care or their service provider for
assistance.
The operational parameters listed on the System Information page are shown in a tabular format. The first (left) column
identifies the parameter categories:
• Identification – Contains system ID information such as Site ID (installation site ID) and ST name (a unique name
that identifies the satellite modem).
• Software – Contains version information on the various software applications resident on the satellite modem such
as commissioning and operational software.
• Satellite – Contains information pertaining to communication with the satellite such as antenna size, transmit radio
wattage, and uplink transmission mode.
• Addressing – Contains addressing information such as LAN port address and subnet mask and available public IP
addresses (if any, depending on your service plan).
66
HN9000 Satellite Modem Installation Guide
1037576-0001 Rev. A
Chapter 8