Hughes dishNET HT 1000, Installation Manual

Page: 35 / 90

Chapter 4 • Installing outdoor equipment and antenna pointing
1039110-0001 Revision A
35
Connecting the IFL cable to the modem
Connect the IFL cable to the connector on the rear panel of the modem as shown in
Figure 18: All connections completed
Figure 18. Figure 18 shows the placement of all connections.
The cable connector must be securely tightened. Make sure each connector is
properly aligned (not cross-threaded). The connector should be finger tight with
no play.
Make sure neither the satellite modem or the customer's computer are connected to
an Ethernet device.
Do not connect any device to the satellite modem at this time except your laptop
computer. Other Ethernet devices may only be connected to the modem after it
installed and commissioned.
Pointing the antenna
Make sure you have the DAPT2. You will need this to point the antenna.
1. Go outside to the antenna location.
2. Follow the procedure explained in the
Jupiter Antenna Pointing Guide
(1039429-0001) to point the antenna using the DAPT2. When you finish the
pointing procedure, a screen message on the DAPT2 asks if you want to store the
NOTICE