Hughes DIRECTV HIRD-B1, Owner'S Manual

Page: 15 / 74

SETTING UP YOUR DIRECTV SYSTEM
P
AGE
2-3
have no jacks like these on your TV or VCR, skip this section and proceed to the “Hook Up the RF
Signals” section.
This video hookup will give you a clearer picture than an RF hookup. Also, this hookup will allow you
to view satellite programming and local broadcast simultaneously on TVs that offer a “picture in
picture” (PIP) feature.
When using this hookup, you cannot use the digital satellite receiver as a switch to choose between
satellite programming and local broadcasts. You will use the input selection that your TV and/or VCR
offer to select the source.
If your VCR has a video input…
use an audio/video cable to connect the digital satellite receiver’s
VIDEO
output to the video input on
your VCR. Also connect the pair of the digital satellite receiver’s audio outputs (Left and Right) to the
audio inputs on your VCR.
If your TV has a video input…
connect an audio/video cable from the
VIDEO
output (either from the digital satellite receiver if
available or the VCR) to the video input on the TV. Also connect the left and right audio outputs from
the same device that the video is coming from and connect them to the TV.
If your hookup is complete…
move on to the “Finishing Up” section.
Hook Up the RF Signals
Look at the back of your TV and VCR for RF inputs. These could be labeled something like 75-OHM,
300-OHM, CABLE, FROM ANTENNA, VHF or UHF. These could appear either as a
pair or screws or a F-type connector as on the back of your digital satellite receiver.
If your TV or VCR does not have threaded F-type connectors you will need to obtain
adapters which convert the round F-type RG-6 or RG-59 cable to the connectors on your
TV and/or VCR. These are sold separately and should be available from your dealer or an electronics
hardware store.
To connect your VCR…
use a coaxial cable to connect the
OUT TO TV
from your digital satellite receiver to the RF input
section on your VCR. This is the first place where an adapter may be needed if your VCR doesn’t have
the F-type connector.
To connect your TV…
connect a coaxial cable from the RF output (either from the digital satellite receiver’s
OUT TO TV
if
available or the VCR) to the RF input on the TV.
Set the channel 3/4 switch on the back of your digital satellite receiver to the channel that is not
broadcast or has the weakest signal in your area. This will be the channel that you need to set your TV
and/or VCR to for viewing or recording satellite programming.
You can also use your digital satellite receiver as a switch to select between satellite programming and
local broadcasts. This can be accomplished by pressing the
key while the remote is in satellite
mode. Also, you must connect your local signal, either from an antenna or cable service, to the
IN
FROM ANT
on the back of your digital satellite receiver. If your antenna wire is not a coaxial type
your will need an adapter as described earlier.
If your hookup is complete…
move on to the “Finishing Up” section.
The RF cable and jack