Hughes AN8-098R, Installation Manual, Page: 29 / 62

Chapter 2 • Antenna parts and required tools
1037752-0001 Revision A
15
Tools
Table 2 lists the tools required to assemble and install the
antenna.
Table 2: Tools and additional materials required to assemble and
install the antenna
Tool or material Details
Socket wrench, ½-inch For 5/16-inch bolts.
2 open-end wrenches,
½-inch For 5/16-inch bolts. Some nuts and bolts
require a second wrench to prevent turning.
Torque wrench With 5/16-inch sockets capable of torquing
to 8 ft-lb.
Long-shaft hexagonal
Allen wrench, 7/64-inch For Allen screws with a 7/64-inch
hexagonal socket. Driver shaft should be at
least 5 inches long.
Torque wrench for
hexagonal socket Must fit a 7/64-inch hexagonal socket and
be capable of torquing to 15 in-lb.
Bubble level Used to make sure that the mast is plumb.
Compass Used to determine antenna azimuth.
Pencil Carpenter’s pencil.
Weather grade silicon
sealant Used to keep moisture away from cable
connections.
Weatherproofing tape Used to keep moisture away from cable
connections.
Approved RG6 cable Used for IFL between satellite modem and
antenna.
UV-rated cable ties Used to secure slack in cables to antenna
mast.